The apps available in different regions will vary based on applicable laws. I could not find the download for the Remote Camera Control Application.Īs you may have noticed, this is the forum page for Canon USA. AutoIP as follows.īy the way, the Remote Camera Settings Guide is not available in German. On the second CR-N300, where I did not change the IP to a manual IP, I could reach the Admin Page without any problems. The situation is that I could control the first CR-N300 with the RC-IP100, but I could not reach this page Admin Page. With AutoIP, I was able to reach the Init page as described in the YouTube video.Ĭurrently I have set the IP address manually two times. In the first step, the Camera Search Tool shows me two CR-N300s with the same IPv4 address 192.168.100.1. One difference from the video is that I don't have an IPV6 address, but I have this default IPV4 address and AutoIP that is shown in Camera Search Tool. I also have a simple network switch to connect the two CR-N300s to the RC-IP100 and my laptop. I am also using my Lenovo laptop - Windows 10 Enterprise 64-bit. Later I will equip them with an ATEM SDI video switcher. I have set these up with a Blackmagic Video Switch ATEM mini pro and an external monitor. All four are brand new and fresh out of the box. I have two Canon CR-N300s, a Canon RC-IP100 and a Canon XA45 camcorder.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |